View TC7PA175FU_4133189.PDF datasheet online --- IC-ON-LINE

Datasheet File OCR Text:

TC7PA175FU
TOSHIBA CMOS Digital Integrated Circuit Silicon Monolithic
TC7PA175FU
D-Type Flip-Flop with Clear Features
* * Operating voltage range: VCC = 1.8~3.6 V High-speed operation: tpd = 3.5 ns (max) at VCC = 3.0~3.6 V tpd = 4.6 ns (max) at VCC = 2.3~2.7 V tpd = 9.2 ns (max) at VCC = 1.8 V * High-level output current: IOH/IOL = 24 mA (min) at VCC = 3.0 V IOH/IOL = 18 mA (min) at VCC = 2.3 V IOH/IOL = 6 mA (min) at VCC = 1.8 V * * 3.6-V tolerant inputs 3.6-V power down protection output Weight: 0.0068 g (typ.)
Absolute Maximum Ratings (Ta = 25C)
Characteristics Power supply voltage DC input voltage DC output voltage Input diode current Output diode current DC output current Power dissipation DC VCC/ground current Storage temperature Symbol VCC VIN VOUT IIK IOK IOUT PD ICC Tstg Value -0.5~4.6 -0.5~4.6 -0.5~4.6 (Note 1) -0.5~VCC + 0.5 (Note 2) -50 -50 (Note 3) 50 200 100 -65~150 mA mA mA mW mA C V Unit V V
Marking
Product name
EAH
Pin Assignment (top view)
CK 1 6 CLR
CK CLR D Q
GND 2
5 4
VCC Q
Note:
D Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum ratings and the operating ranges. Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook ("Handling Precautions"/"Derating Concept and Methods") and individual reliability data (i.e. reliability test report and estimated failure rate, etc).
3
Note 1: VCC = 0 V Note 2: High or Low state. The IOUT absolute maximum rating must be adhered to. Note 3: VOUT < GND
1
2007-11-01
TC7PA175FU
IEC Logic Symbol
CLR CK R C
D
D
Q
Truth Table
INPUTS CLR D X L H X CK X OUTPUT FUNCTION Q L L H Qn CLEAR
L H H H

NO CHANGE
X: Don't care
Operating Ranges
Characteristics Power supply voltage Input voltage Output voltage Symbol VCC VIN VOUT Value 1.8~3.6 1.2~3.6 -0.3~3.6 0~3.6 0~VCC 24 Output Current IOH/IOL 18 6 Operating temperature Input rise and fall time Topr dt/dv -40~85 0~10 (Note 10) (Note 5) (Note 6) (Note 7) (Note 8) (Note 9) C ns/V mA (Note 4) Unit V V V
Note 4: Data retention only Note 5: VCC = 0 V Note 6: High or Low state Note 7: VCC = 3.0~3.6 V Note 8: VCC = 2.3~2.7 V Note 9: VCC = 1.8 V Note 10: VIN = 0.8~2.0 V, VCC = 3.0 V
2
2007-11-01
TC7PA175FU
< DC Electrical Characteristics (Ta = -4085C, 2.7 V < VCC = 3.6 V)
Characteristics High-Level Input Voltage Low-Level Input Voltage Symbol VIH VIL Test Condition VCC (V) IOH = -100 A High-Level Output Voltage VOH VIN = VIH IOH = -12 mA IOH = -18 mA IOH = -24 mA IOL = 100 A Low-Level Output Voltage VOL VIN = VIH or VIL IOL = 12 mA IOL = 18 mA IOL = 24 mA Input Leakage Current Power-off Leakage Current Quiescent Supply Current Increase in ICC per Input IIN IOFF ICC ICC VIN = 0~3.6 V VIN, VOUT = 0~3.6 V VIN = VCC or GND VCC < (VIN, VOUT) < 3.6 V = = VIH = VCC - 0.6 V 2.7~3.6 2.7~3.6 2.7~3.6 2.7 3.0 3.0 2.7~3.6 2.7 3.0 3.0 2.7~3.6 0 2.7~3.6 2.7~3.6 2.7~3.6 2.0 VCC - 0.2 2.2 2.4 2.2 0.8 0.2 0.4 0.4 0.55 5.0 10.0 20.0 20.0 750 A A A V V Min Max Unit
< < DC Electrical Characteristics (Ta = -4085C, 2.3 V = VCC = 2.7 V)
Characteristics High-Level Input Voltage Low-Level Input Voltage Symbol VIH VIL Test Condition VCC (V) IOH = -100 A High-Level Output Voltage VOH VIN = VIH IOH = -6 mA IOH = -12 mA IOH = -18 mA IOL = 100 A Low-Level Output Voltage VOL VIN = VIH or VIL IOL = 12 mA IOL = 18 mA Input Leakage Current Power-off Leakage Current Quiescent Supply Current IIN IOFF ICC VIN = 0~3.6 V VIN, VOUT = 0~3.6 V VIN = VCC or GND VCC < (VIN, VOUT) < 3.6 V = = 2.3~2.7 2.3~2.7 2.3~2.7 2.3 2.3 2.3 2.3~2.7 2.3 2.3 2.3~2.7 0 2.3~2.7 2.3~2.7 1.6 VCC - 0.2 2.0 1.8 1.7 0.7 0.2 0.4 0.6 5.0 10.0 20.0 20.0 A A A V V Min Max Unit
3
2007-11-01
TC7PA175FU
< DC Electrical Characteristics (Ta = -4085C, 1.8 V = VCC < 2.3 V)
Characteristics Symbol Test Condition VCC (V) High-Level Input Voltage Low-Level Input Voltage VIH VIL IOH = -100 A IOH = -6 mA Low-Level Output Voltage Input Leakage Current Power-off Leakage Current Quiescent Supply Current VOL IIN IOFF ICC VIN = VIH or VIL VIN = 0~3.6 V VIN, VOUT = 0~3.6 V VIN = VCC or GND VCC < (VIN, VOUT) < 3.6 V = = IOL = 100 A IOL = 6 mA 1.8~2.3 1.8~2.3 1.8 1.8 1.8 1.8 1.8 0 1.8 1.8 0.7 x VCC VCC - 0.2 1.4 0.2 x VCC 0.2 0.3 5.0 10.0 20.0 20.0 A A A V V Min Max Unit
High-Level Output Voltage
VOH
VIN = VIH
AC Electrical Characteristics (Ta = -4085C, input tr = tf = 2.0 ns, CL = 30 pF, RL = 500 )
Characteristics Symbol Test Condition VCC (V) 1.8 Maximam Clock Frequency fmax 2.5 0.2 3.3 0.3 Propagation Delay Time ( CK-Q ) Propagation Delay Time ( CLR-Q ) tpHL (Figure 1 and 3) tpLH tpHL 1.8 (Figure 1 and 2) 2.5 0.2 3.3 0.3 1.8 2.5 0.2 3.3 0.3 1.8 Minimum Set-up Time ts (Figure 1 and 2) 2.5 0.2 3.3 0.3 1.8 Minimum Hold time th (Figure 1 and 2) 2.5 0.2 3.3 0.3 Minimun Pulse Width ( CK ) Minimun Pulse Width ( CLR ) tw(L) (Figure 1 and 3) tw(H) tw(L) 1.8 (Figure 1 and 2) 2.5 0.2 3.3 0.3 1.8 2.5 0.2 3.3 0.3 1.8 Minimum Removal Time trem (Figure 1 and 3) 2.5 0.2 3.3 0.3 100 200 250 1.0 0.8 0.6 1.0 0.8 0.6 3.0 1.5 1.5 3.0 1.7 1.7 4.0 2.3 2.3 4.0 2.3 2.3 3.1 2.0 1.5 9.2 4.6 3.5 9.2 4.6 3.5 ns ns ns ns ns ns ns MHz Min Max Unit
For CL = 50 pF, add approximately 300 ps to the AC maximum specification.
4
2007-11-01
TC7PA175FU
Capacitive Characteristics (Ta = 25C)
Characteristics Input Capacitance Power Dissipation Capacitance Symbol CIN CPD fIN = 10 MHz Test Condition (Note 11) VCC (V) 1.8, 2.5, 3.3 1.8, 2.5, 3.3 TYP. 2.4 11 Unit pF pF
Note11: CPD is defined as the value of the internal equivalent capacitance which is calculated from the operating current consumption without load. Average operating current can be obtained by the equation: ICC (opr.) = CPDVCCfIN + ICC
5
2007-11-01
TC7PA175FU
Figure 1 Test Circuit
Output CL RL Measure
CL = 30 pF RL = 500
AC Waveforms
tr 2ns 90% VM 10% tf 2.5ns tf 2.5ns tw(H) tw(L) tf 2ns
Input (CK)
VIH GND VIH GND
ts(H) th(H) ts(L) th(L)
Input (D)
90% VM 10%
VOH Output (Q)
VM
VOL
tpHL tpLH
Figure 2 tpLH, tpHL
tr 2ns tr 2ns
VIH Input (CLR)
10% tf 2.5ns 90% VM
Input (CLR) GND
90% VM 10% tw(L)
VIH
GND
Input (CK)
10%
90% VM
VIH
Output (Q)
VOH
VM
GND
trem tpHL
VOL
VOH Output (Q) VOL
Symbol VIH VM
VCC 3.3 0.3 V 2.7 V 1.5 V 2.5 0.2 V VCC VCC/2 1.8 V VCC VCC/2
Figure 3 trem , tpHL , tw (L) 6 2007-11-01
TC7PA175FU
Package Dimensions
Weight: 0.0068 g (typ.)
7
2007-11-01
TC7PA175FU
RESTRICTIONS ON PRODUCT USE
* The information contained herein is subject to change without notice.
20070701-EN GENERAL
* TOSHIBA is continually working to improve the quality and reliability of its products. Nevertheless, semiconductor devices in general can malfunction or fail due to their inherent electrical sensitivity and vulnerability to physical stress. It is the responsibility of the buyer, when utilizing TOSHIBA products, to comply with the standards of safety in making a safe design for the entire system, and to avoid situations in which a malfunction or failure of such TOSHIBA products could cause loss of human life, bodily injury or damage to property. In developing your designs, please ensure that TOSHIBA products are used within specified operating ranges as set forth in the most recent TOSHIBA products specifications. Also, please keep in mind the precautions and conditions set forth in the "Handling Guide for Semiconductor Devices," or "TOSHIBA Semiconductor Reliability Handbook" etc. * The TOSHIBA products listed in this document are intended for usage in general electronics applications (computer, personal equipment, office equipment, measuring equipment, industrial robotics, domestic appliances, etc.).These TOSHIBA products are neither intended nor warranted for usage in equipment that requires extraordinarily high quality and/or reliability or a malfunction or failure of which may cause loss of human life or bodily injury ("Unintended Usage"). Unintended Usage include atomic energy control instruments, airplane or spaceship instruments, transportation instruments, traffic signal instruments, combustion control instruments, medical instruments, all types of safety devices, etc.. Unintended Usage of TOSHIBA products listed in his document shall be made at the customer's own risk. * The products described in this document shall not be used or embedded to any downstream products of which manufacture, use and/or sale are prohibited under any applicable laws and regulations. * The information contained herein is presented only as a guide for the applications of our products. No responsibility is assumed by TOSHIBA for any infringements of patents or other rights of the third parties which may result from its use. No license is granted by implication or otherwise under any patents or other rights of TOSHIBA or the third parties. * Please contact your sales representative for product-by-product details in this document regarding RoHS compatibility. Please use these products in this document in compliance with all applicable laws and regulations that regulate the inclusion or use of controlled substances. Toshiba assumes no liability for damage or losses occurring as a result of noncompliance with applicable laws and regulations.
8
2007-11-01

▲Up To Search▲

Price & Availability of TC7PA175FU

	To Download TC7PA175FU Datasheet File
If you can't view the Datasheet, Please click here to try to view without PDF Reader .